Go Back   Bream Master Forums > Bream Boats > Motors

Motors Get the low down on which outboards perform best…



Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 11-01-2004, 09:00 PM
Alex's Avatar
Alex Alex is offline
Blue Lip
 
Join Date: Jan 2003
Location: Melbourne
Posts: 3,359
Question Where do you take your outboard in Melb?

Ok guys,

It seems to me that nobody knows a good outboard mechanic in Melbourne metro area (refer to my previous post). Then, let me rephrase it.
Where do you take your trailer and outboard for a service in Melbourne (the backyard specialists inclusive).
I cannot believe that there are no other places than JV marine and Boronia where you can service the motor!
Any help would be greatly appreciated.
Cheers,
Alex
__________________
For a healthy livewell contact me and check out the link below:


Monster Miki Addict
Reply With Quote
  #2  
Old 12-01-2004, 09:34 PM
Chris_Macca's Avatar
Chris_Macca Chris_Macca is offline
Poddy Bream
 
Join Date: Feb 2003
Location: Patterson Lakes
Posts: 84
Gales Marine Nepean Hwy Edithvale
Reply With Quote
  #3  
Old 05-02-2004, 12:34 AM
Sandworm Sandworm is offline
Mature Bream
 
Join Date: Mar 2003
Location: South East Subs Melbourne
Posts: 135
what motor is it? brand etc
Reply With Quote
  #4  
Old 05-02-2004, 12:47 AM
Sandworm Sandworm is offline
Mature Bream
 
Join Date: Mar 2003
Location: South East Subs Melbourne
Posts: 135
i just saw its a suzuki, in that case call and book in at leasure sports Marine in safty beach. 4 shops recomended them to me, they specialise in suzuki - most wont touch them. I am booked in this month. (03) 9772 6300

Now i think i have a similar prob to you. My motor started first time, then once i was out in the bay it stalled. then wouldn't start!!! so after getting wet, being pushed into rocks snapping a ore, pushing the boat off rocks back to sea then getting a mate to come down. Then engine started first time!, so i drove the 100m to the ramp where it stopped again not to start.

Once home it started again untill warm then stall's. Water pump works, but somthing is playing up so its getting a service etc

Maybe yours is along similar lines?
Reply With Quote
  #5  
Old 09-02-2004, 05:35 PM
Alex's Avatar
Alex Alex is offline
Blue Lip
 
Join Date: Jan 2003
Location: Melbourne
Posts: 3,359
Hi Sandworm,
Amazingly, the same had happened to me few months back. The engine was worm, we were cruizing at full speed with my son and suddenly the engine stopped! We tried everything-pumping fuel, checking/replacing spark plugs. Then started paddling from Station pier area to the St.Kilda marina. What a job! Tried to start it few more times-nothing. Not even a single cough. Arrived to St. Kilda marina, asked for mechanic-the guy pumped the prime bulb really hard, first pull-bingo! He could not explain the problem, just said "it happens...". Since then-no problems. I replaced a dodgy fuel line connectors, put original Suzuki. But I'd really want to get it serviced properly.
Tell me how you went with your service.
Cheers,
Alex
__________________
For a healthy livewell contact me and check out the link below:


Monster Miki Addict
Reply With Quote
  #6  
Old 19-02-2004, 01:15 AM
Sandworm Sandworm is offline
Mature Bream
 
Join Date: Mar 2003
Location: South East Subs Melbourne
Posts: 135
Alex, the result was a blown engine although it still starts and run's untill warm

hole in the piston (small) so to replace $6500

since i only had the boat for a few days and in the water for about 2 min if lucky

i am very mad. $6K for the boat, and now $6.5 to fix it

GRRRRR
Reply With Quote
  #7  
Old 19-02-2004, 05:10 PM
Alex's Avatar
Alex Alex is offline
Blue Lip
 
Join Date: Jan 2003
Location: Melbourne
Posts: 3,359
Hi Sandworm,
Well mate, .... happens. I suggest you shop around and get alternate quotes to fix the problem, before you commit yourself to big bucks. Seems very steep for the piston replacement though. Try Tony at Footscray Marine 9687 6323.
Cheers,
Alex
__________________
For a healthy livewell contact me and check out the link below:


Monster Miki Addict
Reply With Quote
  #8  
Old 20-02-2004, 10:55 PM
Sandworm Sandworm is offline
Mature Bream
 
Join Date: Mar 2003
Location: South East Subs Melbourne
Posts: 135
thats the price of a new motor

i am told its not worth putting money into a old engine

however its home now and i plan to do it myself because i cant afford a new motor.

I have some pics of damage at the following locations

i thinkg there a bit big (sorry)

to make them work, click on link then del the "http://" and it should work



Back of the Boat / motor

Bore / pistons

Hole in the top piston

Stuffed water pump - note all the tips missing - 3 are on the side others inside engine i guess
Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -4. The time now is 04:37 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Google