|
|||||||
| Hulls Come in here to find info on that next boat you buy… |

![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Opinions please; Would it be ok to put a livewell in a thwart seat by cutting a section out of the seat?
Would this compromise the structural integrity of the hull? If it does go in there what materials would be better to use? When i say cut a section out of the seat I mean the top section leaving the risers/upright sections Any feedback from members who have done this or seen this mod would be appreciated Cheers Brad
__________________
If a shortcut was easy it would just be the way |
|
#2
|
|||
|
|||
|
how big a well do you need?
i tried to get a 90 litre well to fit, only need 60 but you need room for it to slop arpound etc or it goes everywhere i have a 385 explorer and its impossible to fit, so went for a ally tank which sits in the middle of the boat |
|
#3
|
|||
|
|||
|
Cheers Juggs, it's to go in a 420 explorer so i think the dimensions are the same i think i might have to look at other options as i'm looking forabout 110l or so
__________________
If a shortcut was easy it would just be the way |
|
#4
|
||||
|
||||
|
Mate send me PM with your email & i can to show you how mine is my front seat of the Hornet.. It's 65L but it could of been alittle deeper & maybe gone up to 80L which would of been good..
|
![]() |
|
|