|
|||||||
| Motors Get the low down on which outboards perform best… |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|||||||
| Motors Get the low down on which outboards perform best… |
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
01-04-2003, 09:39 PM
|
||||
|
||||
Parts for OLD johnson?
Does anyone know where I can track down some parts for a 1969 johnson 6hp? Is there a old outboard wreckers in perth?
__________________
Proudly associated with: ANYONE WHO HAS A BOAT ANYONE WHO MIGHT GET ONE SOON.... 
|
|
#2
01-04-2003, 09:54 PM
|
|||
|
|||
|
Parts for Old Johnson.
 hehehehehe. Thats almost as good as my "Longest time without rod in hand" thread heading!. Sorry cant help you with your question though! Dave
|
|
#3
02-04-2003, 09:26 AM
|
||||
|
||||
|
Bout' par for the course for today, two left feet, fingers all thumbs and to top it off it turns out english may not have been my native tongue today.
Roll on tomorrow 
__________________
Proudly associated with: ANYONE WHO HAS A BOAT ANYONE WHO MIGHT GET ONE SOON....
|
|
#4
02-04-2003, 10:27 AM
|
||||
|
||||
|
may be able to point you in the right direction
give these folk a call. It can't hurt and they really know their stuff with OMC and may be able to point you in the right direction.
MUHLING JOHN MARINE PTY LTD 2000 18/ 1 Baden St Osborne Park 6017 (08) 9242 3600 I have also seen a guy on the swan with something like a 1960 15HP Johnson that he restored and he has it mounted to a timber dinghy that he built. He launches from the ramp near the ski area at deepwater point. The whole setup is a work of art and he actually chases flathead at dawn. Keep your eyes peeled for him if your out on the swan. The setup is a work of art and he is friendly as well.
|
|
#5
23-05-2003, 12:30 AM
|
||||
|
||||
|
salty dog,
i have a cr71g 6 hp johnson sitting in the shed the only problem is that i live in nsw on the mid north coast the model number is 86178 i believe it is a 1971 model a friend who is a mechanic said they didnt change the 6hp until 1974 and even then three quarters of the parts are changeable, if this helps you any way drop me a email,the poor old girl still turns over, well it did 6 months ago richard
__________________
Proudly Associated with: Nitro Fishing Technologies Secret Creek Lures Shipton Trading Pty Ltd
|
|
#6
10-06-2003, 05:35 AM
|
||||
|
||||
|
Ive got a 15hp Johnson
Yeh if u have any luck i myself need to fix the tilt for my 15hp Johnson motor......although I find the aluminium gaff does nearly as good of a job! I just lift it up and wack it in under it!
Also anyone who has a just got a 15hp Johny dont drive around with it tilted up it stuffs it! Also if anyone would like to buy it it is going cheap and goes like a shower of DohDohDohDoh i tell u 40knots easy!
|
|
|
|
Linear Mode
