|
|||||||
| Bream Anglers Tavern Drop in here if you're just surfing with a beer in your hand. Good place to just hang out... |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|||||||
| Bream Anglers Tavern Drop in here if you're just surfing with a beer in your hand. Good place to just hang out... |
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
25-01-2003, 11:56 PM
|
|||
|
|||
|
what type of screws t ouse on your tinnie
I am getting my tinnie soon, can i use screws into (Not the Hull) the boat to mount things like rod holders cleats etc . I take it certain metals like brass will cause corrosion, is stainless steel suitable, (I see that they sell stainless steel fasteners in boat shops)?
|
|
#3
26-01-2003, 01:20 AM
|
||||
|
||||
|
Hi Rodmy.
Stainless steel screws are fine. But I strongly suggest that you also buy yourself a tube of Duralac. It's an anti-corrosive jointing compound which inhibits electrolytic corrosion between dissimilar metals. A tube will cost you around $25 but will last you the life of your boat (generally)
__________________
Regards, Michael Last edited by Big Muddie; 26-01-2003 at 01:25 AM.
|
|
#4
26-01-2003, 02:49 AM
|
||||
|
||||
|
Listen to Big Muddy about the stainless/Duralac combo - you'll never have a problem for the life of your boat
__________________
Dave  Never get so busy making a living that you forget to make a life! Team BreamMaster Member
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
