|
wiring
. . . . . also, run some twin core 6mm wire with fuse (15 or 20amp depending on total load) at isolator or battery. Run that up to the dash with earth going to buss and + to either a buss or your switch panel. If you don't solder and seal you can get heat shrink joiners from a marine shop - expensive but worth it - they seal up after crimping, with a lighter.
__________________
_________________________________________
You are always better off being marinated by an aquaholic.
PB: No way, you'll just laugh!
Member of Mandurah Breaming Association
|