Casting seat
Any advice on where to get or how to build a casting seat/lean seat to suit my 2006 Hornet trophy 400? The ones on offer through Quintrex are very expensive and not height adjustable and most of the pedestals i've seen are the wrong diameter for the quinnie. I've seen the Springfield Pro "stand up" seats for sale at good prices but any advice on the pedestal would be great.
|
Lean Seat
Gday Jock
I have a 435 Hornet and have been after one as well , I have been told they are a rare find and to look on Ebay and Gumtree to find a used one , if i find a solution on how to build one i will let you know Steve J |
1 Attachment(s)
Is this how your casting deck is set up
|
hey mate, look into buying the seat (ive seen them at b c f), and then get someone to fabricate up a pole with a plate on top to screw the seat on. i looked into the same thing a while ago for my hornet
|
1 Attachment(s)
and this is the pedestal - do you know what diameter pole they use - because Pvc piping can be used to make up the difference on skinnier poles - you just cut off a length and put it over the pole so it doesnt rattle around
|
Just did some searching and found this -
if I was a more cynical man I'd say - It almost looks as if they have designed their front deck so it wont take anything but a Quintrex post;). But where theres a will, theres a way Quote:
|
I have just re-decked my tinny & have a lean seat with base plate (basically same as pic by yellow door) I'm in Albury Wodonga so if anyone wants it let me know. Phil
|
Yes this is similar Yellow Door but mine is a 2006 model so there is a step as well. The diameter of the other pedestals is 50mm I think.
|
My lean seat has gone
|
Casting Seat
JOCK578.
Where are you located ? I've got a Lean / Pedestal Seat & Post from a Skeeter ZX190 that might suit what your looking for.. |
I'm in Kyneton VIC, what area of Melb are you ZX190?
|
All times are GMT -4. The time now is 08:00 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.